|
Email: Questions or Comments about this site? Webmaster I Accept
Email: René Rondeau ![]() Member of American Watchmakers-Clockmakers Institute and the National Association of Watch & Clock Collectors since 1986. |
|
To turn off the
watch, simply pull out the setting stem. This will prevent unnecessary
wear on the fragile contact surfaces, adding years to its operable
lifetime. If it does not start when the
stem is pushed in, gently rotate the watch to set the balance
wheel in motion. BATTERIES: You can damage your watch or break
the battery clamp if you attempt to install an incorrect battery.
For the Model 500 and 500A movements use the Eveready 387S (note:
if you replace the battery yourself, exercise extreme caution
to avoid touching the exposed contact wires in the Model 500 or
500A). In the Model 505 use a number 301 or SR43SW. However, only
batteries made by Renata, Sony, and Panasonic will fit correctly.
(Energizer and Maxell have changed the shape of their batteries
and they should NOT be used in the 505!) It is advisable to put
a small piece of ordinary tape on the negative side of the battery
with just a small cutout for the cell lead to touch. This insulation
will prevent any possibility of an accidental short circuit..
If your
watch does not work with a new battery, send it to me for expert
servicing!
|